Stoves "Varvara" for baths: review, characteristics and customer reviews

The range of these sauna stoves

As he declares himself to produce steel for baths after a thorough analysis of the pros and cons of domestic models - and therefore all the pros and cons of competitors are taken into account here.

Any model of "Barbara" to create a comfortable temperature regime and good steam in the bath. And there are three main serial "Barbarian":

Furnace with a heating circuit and a tank that is located at the top and has a capacity of 120 liters.

These stoves are designed for those baths where there is a water supply system or a pumping station with water supplied to it. Here, the tank is essentially a passage through the ceiling. Steam from such a furnace is discharged outside through a steam outlet. And the heating circuit itself is made of stainless steel 1.5 mm thick, where hot water circulates. Such a stove will cope even with a steam room up to 30 m3. By the way, if such a large tank is not needed, it can be replaced with a standard 60 l.

Oven with a side-mounted tank - 50 liters.

This model is ideal for baths in which there is no way to connect or organize a water supply. But such an oven is record-breakingly fast and easy to install, easy to maintain and serves for a long time and without problems due to its simplicity.

Oven without a tank - with and without a circuit.

Furnaces with a circuit are designed to heat water using electric and gas water heaters. But "Barbara" without a circuit is used more as a solid fuel boiler, which is connected to the batteries of the bath and so it is heated.

Mini-stove for a bath "Varvara" and general model range

Sauna stoves "Varvara" are popular due to their simplicity and ease of use. They also have thick, strong walls (not less than 6 mm), which makes it possible to operate the stove for a long time.

Models of sauna stoves "Varvara":

Palenitsa (Palyanitsa, Woodpile) is a very popular stove. It differs from other models by the presence of convection holes on the side of the device. The price of such a stove is one of the most affordable, while its power reaches 12 kW. It can be sold without a circuit or with a side mounted 55 l tank.
Story - a stylish and effective model that allows you to very quickly warm up the desired room. It keeps heat well, does not need cladding and fits perfectly into any interior. There is a panoramic door made of heat-resistant glass.
Terma-Fairy Tale - this model has a closed heater and heats up to a higher temperature. The stove's lining smooths out the heat from the metal and creates a soft, pleasant steam in the sauna.
Mini - a small, compact double-convention stove for saunas with a small area. It can also have a hinged side fluid tank. Additionally, you can order an enlarged firebox, connection to the water circuit. The water heating tank has a displacement of 41 liters. All mini models are designed to heat a room no more than 12 cubic meters. m.
Kamenka - has an outer mesh for lining with stones, which can be laid up to 180-190 kg, which makes it possible to keep warm for a long time, despite the modest dimensions of the stove.
Terma-Kamenka - has a mesh casing and a closed heater. Ideal for a real Russian bath. It takes up little space, it usually takes an hour and a half to warm up a steam room.
Classic Is the simplest model. It is used only for heating the heater and heating the air in the steam room. It has no additional functions.

Mini-stove for the Varvara bathhouse has an excellent appearance, therefore it is able to improve the aesthetic qualities of the bath

In addition to the modifications listed above, the wood-burning models "Comfort" and "Brownie" are also popular. They are inexpensive, very easy to use and perfectly heat the room.You can even cook food on them. But this is not quite a sauna option. Installation instructions for such devices are freely available in the vastness of the network.

Advantages and disadvantages of Barbara

One of the important advantages of the "Varvara" sauna stoves is that they do not weigh at all a lot: the stove itself is 100 kg and, in addition, there is a pipe to it. Absolutely any floor in the bathhouse will pull such a weight, and therefore you do not need a particularly powerful foundation for the stove - sometimes you can do with just good insulation.

And what is just wonderful is that the “Varvara” sauna stove has a round hole with a plug on the back wall - especially for cleaning. And the place that needs to be cleaned near this stove can be easily seen with the naked eye: we look inside the firebox and see in its upper part a welded sheet of metal (it is also called a "smoke tooth") - this is where all the settled soot accumulates. Yes, the Varvara stove requires maintenance - twice a year to clean the pipe and the afterburner. That's all the trouble!

Sometimes these stoves are not favored due to the fact that the water in the tank heats up longer than in conventional stoves. But the solution to this problem is simple: we install an additional heat exchanger on the chimney, and in an hour the water will be about 70 ° C, which is quite enough. True, after three hours it may start to boil - you will have to monitor this.

Another common problem that owners of the Varvara sauna stove often encounter is condensate flowing down the pipe. This happens if the chimney was assembled "by smoke". The thing is that the "Varvara" is a furnace with an afterburner, and it works mainly in a slow burning mode. Therefore, the temperature at the outlet of the chimney turns out to be small, and the condensate forms quite generously, and even with impurities

That is why it is so important to install the Varvara according to the correct scheme - you can see it in the step-by-step photo below. And the pipe itself should not be made 1.2 meters, but passing through the entire tank is longer by as much as half a meter.

So the condensate will drain clean and will not come into contact with the stove smoke.

It is also undesirable to heat this stove with birch wood - there were cases when the seams of the stove simply diverged.

Popular sauna stove "Varvara": reviews of the owners

When choosing any product, one should not only carefully study its characteristics, but also read the reviews of its owners. The same applies to the Varvara ovens.

So what consumers are saying:

Irina. We bought a “Varvara” stove without a circuit to use it for our bath. And you know, I'm very happy! Firstly, it is a very economical device, and secondly, it is completely undemanding to fuel (we threw any tree into the furnace, even just dry branches). I was pleased with the presence of a protective screen in front of the furnace, which makes the use of the device safe.
Igor. I bought a “Varvara-mini” stove for my steam room, which perfectly fit into our interior. Small, economical, easy to use. A side tank of 35 liters is enough for 3 people to steam. By the way, they bought it quite inexpensively.
Egor. I bought the Palenitsa sauna stove many years ago. At first there was a lot of condensation, but then I brought the chimney up and the problem was solved. I did not find any other shortcomings.
Anton. I bought Kamenka. I am satisfied with the purchase. The bath heats up in an hour, firewood is very economical, a lot of steam. But often you have to clean the chimney and the chamber, because the draft decreases.

Compare prices for Fireplaces and stoves Varvara

Furnace Varvara Brownie reviews

Ilya Yakovlev ★ Advantages:
good appearance.
Disadvantages:
not a stove, but horror. I trusted the manager that convection would give off heat with a minimum of firewood. in fact, the hole for the hood was made not at the end of the stove, as usual, so that there was good traction, but at the door and until the whole garage was melted in the smoke of heat from it to zero I want to remake the hole for the hood. cooked more than a dozen ovens, was too lazy and decided to buy a factory one for which he paid.Alexandra. ★
Advantages:
Compact
Disadvantages:
The stove did not burn without alteration, it was necessary to make a hole in the spark arrester for traction.
Comment:
Disposable item. faith g. ★★★★★
Advantages:
Honest steel 4 ka, cast iron grate. Standard chimney size. Heats up the garage quickly
Disadvantages:
The stove is cheaper than the chimney) Buy with a discount

Cons ovens "Varvara"

The long-term use process helped to identify some of the shortcomings of such installations:

The heating time of a large water tank is longer than in similar types of furnaces from other manufacturers. As a justification, one should mention the existence of containers, the reduced dimensions of which reduce the heating time. Another way to deal with the problem is to install an additional heat exchange loop on the pipe. The problem is being solved, but it becomes necessary to constantly control the temperature of the liquid, which can actually boil.
The used principle of slow combustion and the presence of an additional chamber for the complete disintegration of all gases, together with improper installation of the pipe, leads to the accumulation and flow of condensed water droplets along it. For the oven to function properly, the pipe must be long and protrude beyond the top of the tank.

Furnace design

The simplicity of the device "Barbara" - the basis of its attractiveness. Structurally, it is represented by a set of nodal elements:

Stove firebox. This is where firewood is burned. The released energy is transferred to the main structure in the form of heat.
Next to the firebox there is a chamber where the final decomposition of the formed gases (flue gases) takes place.
The system of the ash pan and cast iron grates allows you to regulate the combustion process (its intensity), creating an air flow into the furnace. Another function of the unit is to collect solid combustion products (ash and coals).
Sophisticated chimney design.
A casing that transfers its own heat to the surrounding air masses and heats the stove.

A significant difference between the furnaces is the use of a special opening on the rear of the main body in order to clean the combustion zone from soot.

For models equipped with a heating circuit, a tank is used, for the manufacture of which a stainless alloy is used, the sheet thickness of which is at least 1.5 mm.

Device

There is a whole range of Varvara stoves. In order to disassemble the device of the Dero and K brand products as accurately as possible, let us dwell on the simplest of them. This sauna stove is not an economic or technological miracle.

Its structure is quite typical and simple:

The combustion chamber is the place where fuel is burned. Since the stove is wood-fired, any wooden logs will do.
Afterburning system - here flue gases that were formed in the firebox break up.
The grate and ash pan are helpful in collecting wood residues.
A sophisticated chimney system works as efficiently as possible when properly installed.
The protective cover provides heat transfer to the room.

An important component of the Varvara oven is its cleaning system - a hole with a plug on the back of the stove, which can be easily cleaned from soot with an ordinary brush. But such a hole appeared only years later in the latest models. Professionals suggest that you can make a place for cleaning yourself in outdated stoves. The cutout should be in the upper third of the rear wall and fall directly into the flue duct.

The main thing is to be careful and create maximum tightness in this particular place, that is, to also make a tight plug.

Additional elements

The same supplier has a number of add-ons that can be additionally ordered and installed in the bathhouse.

External combustion chamber. It happens that the wall between the steam room and the rest room does not allow bringing the firebox into an adjacent room. Therefore, they are made immediately with different sizes of furnaces: shortened, standard and elongated.
Hinged tank. It is a classic water tank that is attached to the left or right in a specially designated recess - a pocket. The tank is made entirely of stainless steel with a thickness of no more than one millimeter.

Panoramic door is more of a decorative element than a practical and functional one.
Water tank, located on the chimney pipe, allows you to use a shower if the bath is equipped with a water supply.
Heat exchanger. An additional element for heating water in a tank located at a remote distance from the stove. It is very important to monitor the filling of the heat exchanger. If it is not complete, then this can lead to its depressurization.

This sauna stove is good in that it can harmoniously fit into the interior of any bath in its original form, or it can serve efficiently and effectively, lined with brick. At the same time, it attracts into the room not just the Russian spirit and aesthetic value. Thanks to this installation, additional power appears to accelerate the heating of the steam room.

Thus, the Varvara stove acquires the image of a domestic stove designer, which will very easily adapt not only to the preferences and additional requests of its owner, but also fit into the interior of any small or large-sized Russian bath.

"Varvara" with brickwork

The usual case of representatives of this series has a very attractive appearance, but for lovers of the Russian spirit of the bath, it is proposed to use the method of creating an additional brick screen.

The benefits of this improved design are:

increased heat capacity constructions. The brick will accumulate the received energy, and give it away gradually, as it cools;
special, different from analogs design (especially if natural stone is used instead of brickwork);
along with the appearance, another filling of space appears dry heat, peculiar only to the steam rooms of Russian baths.

The main disadvantage of this installation method is considered large brick mass, which, superimposed on the weight of the furnace, leads to the need to install a new furnace foundation.